Question 1

I have a small in-ground plunge pool (south Florida climate), around 1000 gals. I see the TruClear is rated to 35,000 gals. Will it work on a much smaller pool? TIA - View answer

Asked 1 ´year ago | Salt Chlorinators > Jandy® TruClear Salt Chlorine Generator "Trade Grade" - With Plumbing Unions

Question 2

I have a cold reading on my panel will the flow switch cause this reading View answer

Asked 1 ´year ago | Generic Flow Switch (with Temperature Sensor) - PVC Tee Fitting Not Included

Question 3

Will the cell ever need to be replace and if so how often? View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool Universal25 Salt Chlorine Generator

Question 4

I have an intellichlor ic 30 . Will a ic 20 fit as a replacement? View answer

Asked 1 ´year ago | APX PERFORMANCE P60 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC60® Salt Cells | up to 60,000 gallons

Question 5

Will this cleaning stand fit the Circupool Edge series? View answer

Asked 1 ´year ago | Parts > Convenience Kit - Value Pack

Question 6

I have an ichlor 30 pentair system. Will an IC 40 apex replacement cell be compatible with my pentair power supply? View answer

Asked 1 ´year ago | APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 7

I have a salt generator and it need repair and check up, where I can send it for repair.Thank you View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool RJ-20 PLUS Salt Chlorine Generator

Question 8

Do you have the installation instructions available? View answer

Asked 1 ´year ago | Filters > CircuPool TJ-16 "Typhoon" Centrifugal Pre-Filter

Question 9

Are there any compatibility problems replacing a Hayward Aquarite W3AQR3? View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool RJ-20 PLUS Salt Chlorine Generator

Question 10

I recently purchased the Waterco CC150 from you and installed it. From the very start, the pressure gauge reads zero. I removed the gauge to see if it had anything blocking it, reinstalled and it never reads anything but zero. I don't think this is normal. Shouldn't it have a reading while the pump is running? View answer

Asked 1 ´year ago | Filters > Waterco CC150 Trimline Slim Cartridge Filter - 150 Sq. Ft.

Question 11

Does this core fit the older design Core-35 generator with the white upper housing? View answer

Asked 1 ´year ago | CircuPool CORE35 Replacement Salt Cell

Question 12

Is it compatible with Hayward gold line temperature sensors, and what is the diameter of the pvc ends View answer

Asked 1 ´year ago | CircuPool EDGE Flow/Temperature Sensor PVC T-Fitting

Question 13

add says free shipping but checkout shows 22.00. which is it? View answer

Asked 1 ´year ago | APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 14

I have an IC 60. Will the Apex P15 replacement cell plug directly into and use the existing Pentair power center for control? View answer

Asked 1 ´year ago | APX PERFORMANCE P60 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC60® Salt Cells | up to 60,000 gallons

Question 15

What size variable speed pump would I need for a 22,000 gal in ground pool View answer

Asked 1 ´year ago | Pumps > Hayward® TriStar VS Pump

Question 16

Does the Circupool Edge bypass cell fit Circupool Universal 40? View answer

Asked 1 ´year ago | Parts / Accessories > CircuPool EDGE Bypass Cell

Question 17

If you don't use acid to clean the cell, how do you clean the cell? I need to replace my Pentair Intellichlor that never lasts more that 1-2 years with regular (every 6 weeks) cleaning with acid. View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool SJ-55 Salt Chlorine Generator

Question 18

What is the recommended method of cleaning this aftermarket cell. With acid, like the Intellichlor? View answer

Asked 1 ´year ago | APX PERFORMANCE P60 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC60® Salt Cells | up to 60,000 gallons

Question 19

Looking to buy a MegaChlor-CD for my 6,500 gal. above ground pool. What exactly is the CM-PS -HIDE. Is it a mounting box so the control unit is not exposed to the elements? View answer

Asked 1 ´year ago | Salt Chlorinators > ControlOMatic - MegaChlor Pool and Swim Spa Chlorine Generator

Question 20

I have a older 60k do you have a cell for it View answer

Asked 1 ´year ago | Salt Cells > CircuPool® RJ-60 PLUS Replacement Cell

Question 21

My current Pentaire I 40TH (I think) allows me to view, change percentage output and read salt level thru my phone app....will this allow me to do the same via the app? if not, are there any? View answer

Asked 1 ´year ago | APX PERFORMANCE P60 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC60® Salt Cells | up to 60,000 gallons

Question 22

Does this replacement cell come with the new cord or is that sold separately? View answer

Asked 1 ´year ago | Autopilot PPC1 Replacement Salt Cell (for RC-35/22, SC-36 cells)

Question 23

Could I replace the CircuPool CORE 35 cell with a CORE 55 cell? View answer

Asked 1 ´year ago | CircuPool CORE35 Replacement Salt Cell

Question 24

¿Pueden enviar una celda del modelo CPSC-16 de 4 placas a -Murcia- España? View answer

Asked 1 ´year ago | Salt Cells > APX PERFORMANCE C4 Aftermarket Replacement Cell fits CompuPool CPSC-16 | up to 16,000 gallons

Question 25

Can the Typhoon Pre Filter be installed on it’s side or does it need to be upright? View answer

Asked 1 ´year ago | Filters > CircuPool TJ-16 "Typhoon" Centrifugal Pre-Filter

Question 26

I have a 40000 gallon pool with a hayward aquarite goldline plus system. My old cell kept giving a low salt reading so i put in more salt several times but it did not change. I ordered your replacement cell and the diagnostics said 6400 ppm salt level. I drained maybe 15,000 gallons and refilled it and the salt reading in diagnostics is still 6400 ppm. Any suggestions? View answer

Asked 1 ´year ago | Salt Cells > CircuPool® GEN15 Aftermarket Replacement Cell fits Hayward® AquaRite® 40,000 Gal. Models

Question 27

Can the unit be installed vertically ? My plumbing would except this with little to no modifications if so. If not, not a big deal. I figured I'd ask. Thank you. View answer

Asked 1 ´year ago | CircuPool EDGE-40 Salt Chlorine Generator

Question 28

Does this flow sensor include a temperature sensor? My chlorinator displays “hot water” and is not working. Troubleshooting states to change the temperature sensor, but I can’t locate one. View answer

Asked 1 ´year ago | [categoryname] > APX PERFORMANCE P-Series Flow Switch for P20, P40, P60

Question 29

What is the water temperature that the Edge 40 system uses to shut off the salt cell during cold weather? View answer

Asked 1 ´year ago | CircuPool EDGE-40 Salt Chlorine Generator

Question 30

I just purchased the Edge 40 and will likely need to install it vertically. Will this kit work with the Edge 40? View answer

Asked 1 ´year ago | Parts > CircuPool Vertical Installation Kit

Question 31

I have a Monarch ESC 36. Will the plumbing be the same? View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool Universal40 Salt Chlorine Generator

Question 32

My current timer has freeze guard built in. Does your pump have freeze guard built in if I use your timer on pump? View answer

Asked 1 ´year ago | Pumps > CircuPool SmartFlo® Variable Speed Pool Pump - 1.7 THP

Question 33

The provided power cable will not be long enough to reach my timer box. How would you recommend extending it to be hard-wired to the timer box? View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool CORE-55 Salt Chlorine Generator

Question 34

Will this house a RJ45plus cell ? View answer

Asked 1 ´year ago | Parts > CircuPool Clear Housing for RJ Classic

Question 35

can i use a cpsc24 salt cell on a cpsc16 system thanks View answer

Asked 1 ´year ago | Parts > CompuPool Clear Housing Fits All CPSC

Question 36

Will this work for the IC40 Cell? View answer

Asked 1 ´year ago | [categoryname] > APX PERFORMANCE P-Series Flow Switch for P20, P40, P60

Question 37

do you ship to the uk View answer

Asked 1 ´year ago | Salt Cells > APX PERFORMANCE C4 Aftermarket Replacement Cell fits CompuPool CPSC-16 | up to 16,000 gallons

Question 38

I have a jacuzzi salt cell and it looks very similar to the RJ classic. I want to go with the Edge will the adapter kit work with my current configuration? View answer

Asked 1 ´year ago | Parts > CircuPool EDGE Adapter Kit (from existing RJ-Classic Models)

Question 39

How many gallons is my pool? View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool SJ-55 Salt Chlorine Generator

Question 40

how to estimate size of pool View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool SJ-55 Salt Chlorine Generator

Question 41

I bought a CIFCGEN IC40 from you March 1, 2022. It has worked fine. Now, however, the light is on that says "inspect cell". The troubleshooting guide says this could mean it needs to be cleaned. I tried that and the light is still on. Do you think it is simply used up. Is there any way to check to see if it has any life left? View answer

Asked 1 ´year ago | APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 42

Does the Pentair app work / talk to this device? If not, does it have its own app for remote monitoring? View answer

Asked 1 ´year ago | APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 43

Can the TJ16 pre-filter be installed before the pump to protect it from sand particles? View answer

Asked 1 ´year ago | Filters > CircuPool TJ-16 "Typhoon" Centrifugal Pre-Filter

Question 44

Can this be an initial install and not a replacement of an existing chlorinator? DYI of course. View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool Universal55 Salt Chlorine Generator

Question 45

I am looking to convert my 27ft above ground to salt. My filter is connected with flexible plumbing, can this be used with flexible plumbing, or will I need to have hard pvc installed? View answer

Asked 1 ´year ago | CircuPool EDGE-40 Salt Chlorine Generator

Question 46

What is the replacement cell for Hayward 940SWB View answer

Asked 1 ´year ago | Salt Cells > Replacement W3 T-CELL-3 Turbo Cell for Hayward® AquaRite® (AQR3)

Question 47

Can it be mounted ( Plumbed) vertically? View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool CORE-15 Salt Chlorine Generator

Question 48

Does the dummy cell come with gaskets? Mine are worn out and the gaskets used for the acid cleaning kit are too big. View answer

Asked 1 ´year ago | Parts > Bypass Cell (fits Pentair® IntelliChlor® Salt Systems)

Question 49

Can I put a 540 replacement cell in a 320 system? I know it will fit, but will the system function properly. View answer

Asked 1 ´year ago | Salt Cells > APX PERFORMANCE S3 Aftermarket Replacement Cell fits Saline Generating Systems® Breeze® 320 (now CMP® PowerClean Salt®)

Question 50

Is this compatible with the IC-30? View answer

Asked 1 ´year ago | APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Browse by Topic

Tools