CircuPool Universal40 Salt Chlorine Generator Q&A

Question 1

Will this communicate with Jandy Aqualink? View answer

Asked 4 ´years ago

Question 2

Can the CircuPool 40 universal be installed vertically or horizontally? View answer

Asked 4 ´years ago

Question 3

I had the notion that a pool salt water chlorine generator would actually deplete dissolved salt when creating free chlorine and it counterpart ion HClO3) Hypochlorus acid . Is the salt (NaCl) actually consumed without returning to it prior state as salt? Since temperature might play a part in chlorine adn/or salt consumption, what is the range of expected salt consumption per 1000 gallons or pool capacity in a hot climate like Palm Springs (summer vs winter). 3200 ppm of salt is supposed to be the ideal concentration, to maintain the salt pool, right? Online, no one seems to address the salt consumption rate issue in Q and A's View answer

Asked 4 ´years ago

Question 4

Is the install a direct replacement for the aquarite Aqr9? Does the hayward Tcells work with this system? View answer

Asked 4 ´years ago

Question 5

Is the Circupool 40 compatible with a Jandy control system. How do I wire it? View answer

Asked 4 ´years ago

Question 6

does this system have an automatic shutoff View answer

Asked 3 ´years ago

Question 7

24000 gallon pool. how much salt is needed View answer

Asked 3 ´years ago

Question 8

Does the unit use 110V or 220V US power? View answer

Asked 3 ´years ago

Question 9

With a variable speed pump will it generate desired out put on low speed setting? View answer

Asked 3 ´years ago

Question 10

Would this unit work well on a 10,000 gal pool located in Phoenix? View answer

Asked 3 ´years ago

Question 11

My Jandy AquaPure IE died recently, is this a suitable replacement, based on the Jandy install and the required install for this one? View answer

Asked 3 ´years ago

Question 12

Will it produce chlorine while pump is on very slow speed? View answer

Asked 3 ´years ago

Question 13

Can I leave my pentair chlorine feeder In place and install the cell ahead of it without removing the feeder. That way I can use both if needed. View answer

Asked 3 ´years ago

Question 14

I don't want to assume, but is it weatherproof? View answer

Asked 3 ´years ago

Question 15

what should i use to take the cell off for cleaning? View answer

Asked 3 ´years ago

Question 16

what levels are recommended for cya ,alkalinity and calcium for a ul40 circupool generator? View answer

Asked 2 ´years ago

Question 17

Can this be put in line with the pump on a timer? View answer

Asked 2 ´years ago

Question 18

what is the amp draw on the universal 40 generator View answer

Asked 2 ´years ago

Question 19

Do you finance View answer

Asked 1 ´year ago

Question 20

What is the cell version setting for the UL40? View answer

Asked 1 ´year ago

Question 21

Will this be okay for 10k gallon pool with filter cartridge or do i need a sand filter as well?? View answer

Asked 1 ´year ago

Question 22

Does the salt comes with it View answer

Asked 1 ´year ago

Question 23

I need replacement union and nuts for a universal 40 cell the nuts are cracked on mine now View answer

Asked 1 ´year ago

Question 24

why is my cell voltage for model ul40 0.0V View answer

Asked 1 ´year ago

Question 25

I have a Monarch ESC 36. Will the plumbing be the same? View answer

Asked 1 ´year ago

Question 26

I don’t have my sand filter hook up with PVC pipes just the tubing stuff. Will it still work for me? Thanks. View answer

Asked 10 ´months ago

Question 27

I take it this unit (Umiversal 40) will replace a Jandy and be more than efficient on a 30,000 gallon pool or would I be better off choosing the upgraded R30 to R45? I might be wrong on the model initial. I cant change pages without loosing my Question page but I'm sure you get the idea, right? View answer

Asked 7 ´years ago

Question 28

I have my Hayward hard wired..Will yours work? Due to I dont have a outlet there View answer

Asked 5 ´years ago

Question 29

Can I use this with my sand filter ?Does this include the cell and what is the cell replacement cost? View answer

Asked 5 ´years ago

Question 30

Can a smaller inline like the CircuPool Universal 25 be used for a Hot Tub? Do these units shut off when they detect suffcient chlorine in the water?Thanks! View answer

Asked 4 ´years ago

Question 31

Is it OK for this cell to be installed vertically, or does it need to be installed horizontally? View answer

Asked 7 ´years ago

Question 32

Does this have all the equipment necessary to replace a chlorine system? View answer

Asked 7 ´years ago

Question 33

How long is the cord on the cell that ships with this unit? View answer

Asked 7 ´years ago

Question 34

Can this system be used in above ground pools? View answer

Asked 8 ´years ago

Question 35

Can you use an existing Hayward flow switch? View answer

Asked 8 ´years ago

Question 36

The unions have a round rubber O-ring that is placed between them to seal the connection. Where can replacements be fou View answer

Asked 8 ´years ago

Question 37

will this replace a Pentair ic40 with out cutting plumbing except for flow switch ? View answer

Asked 7 ´years ago

Question 38

Are there replacement cells for this unit? If so, what model? View answer

Asked 8 ´years ago

Question 39

Does this include all the parts needed? View answer

Asked 8 ´years ago

Question 40

I HAVE AN ORIGINAL GOLDLINE AQUARITE T15. WILL THIS BE A NO CUT INSTALLATION AS FAR AS THE CELL IS CONCERNED?.... WOULD I BE ABLE TO USE THE OLD T15 SALT GENERATOR WITH THE NEW SYSTEM? View answer

Asked 7 ´years ago

Question 41

Were can I find the dimension for the cell length? View answer

Asked 7 ´years ago

Question 42

How difficult is it to install ? View answer

Asked 7 ´years ago

Question 43

Do I need a timer for this unit to work properly ? View answer

Asked 6 ´years ago

Question 44

Is this user friendly enough to be installed without professional help? View answer

Asked 5 ´years ago

Question 45

I know the cell itself can be installed either vertically or horizontally, can the flow switch be plumbed in vertically or does it need to be horizontal? View answer

Asked 1 ´month ago

Question 46

I have a Resilience salt system and I believe it's beginning to fail. Parts are hard to find and expensive. How much of a job would it be to replace it with this? View answer

Asked 7 ´years ago

Question 47

what controls the pump? Is the pump cycled by the same customer supplied timer that energizes the sanitizer? Or does the sanitizer control the pump during the sanitizer cycle, reducing run time on the pump? View answer

Asked 7 ´years ago

Question 48

does it matter which direction the cell is mounted for the flow? View answer

Asked 7 ´years ago

Question 49

Is okay to wire this unit so it powers on and off when the pump is turned on and off? View answer

Asked 7 ´years ago

Question 50

Can the replace jandy aquapure 1400? View answer

Asked 7 ´years ago

CircuPool Universal40 Salt Chlorine Generator Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools