CircuPool CORE-35 Salt Chlorine Generator Q&A

Question 1

circupool core 35..., what is the distance from top of return pipe to top of electronic keypad?I have a lid that cover the pump and filter. View answer

Asked 3 ´years ago

Question 2

If the SWG is plugged in rather than hard wired, what happens if the pump stops operating? Is there a low flow detection that stops the SWG? Could the interruption of water flow damage the unit? View answer

Asked 10 ´months ago

Question 3

Can the CORE35 be installed vertically? View answer

Asked 1 ´year ago

Question 4

Can this be started with a pool already chlorinate with chemicals. View answer

Asked 1 ´year ago

Question 5

How often do i have replace salt. What type of salt is used. View answer

Asked 1 ´year ago

Question 6

Will it stink eyes that are open under water? View answer

Asked 1 ´year ago

Question 7

Will this work for a 13500 gallon pool? your instructions say 1.5 to 2 times the size, but not a maximum multiplier. View answer

Asked 2 ´years ago

Question 8

Will the Core 35 fit in line were a Hayward saltsystem already exists or will you have to make modifications to the existing plumbing? View answer

Asked 2 ´years ago

Question 9

i have a jandy aquapure system now and have to keep salt level above 4000, i would really like to be able to run lower levels, as mine is over 10 years old, can you recommend a better system?, thank you View answer

Asked 2 ´years ago

Question 10

Do you sell the replacement cells for this? I am wondering how much they cost. View answer

Asked 2 ´years ago

Question 11

Are the Electrolytic cells replaceable ? View answer

Asked 2 ´years ago

Question 12

Do I need to get a separate timer for my plug that I will plug my generator. My pump and heater are hardwired . On a timer. My salt generator will not bel wired into pool timer. View answer

Asked 2 ´years ago

Question 13

When purchased what's included? Also what payment options do you provide? View answer

Asked 2 ´years ago

Question 14

I have a Core35, can I change just the cell internals to the Core55 cell and use the Core35 controller ? View answer

Asked 2 ´years ago

Question 15

Can this unit be installed on a vertical return line? View answer

Asked 2 ´years ago

Question 16

What size would you recommend for a 12k gallon pool? Also what would you recommend doing to protect this unit during winter? View answer

Asked 3 ´years ago

Question 17

These units are made to be out in the weather correct? I.E. Rain, wind etc.> No enclosure is required? View answer

Asked 3 ´years ago

Question 18

Can I swim when this is in use View answer

Asked 3 ´years ago

Question 19

I have a small inground pool 6,600 gallons. I like to run my variable speed pump on lower speeds. (Energy savings) What is the minimum GPM for the proper operation? Thanks View answer

Asked 3 ´years ago

Question 20

What size of south system I need for 40,000 gallons View answer

Asked 3 ´years ago

Question 21

I have a 40,000 gallon pool can I use the core 35? View answer

Asked 3 ´years ago

Question 22

How wide of an opening do I need to install this unit. I don’t see that in the specs. View answer

Asked 3 ´years ago

Question 23

What size pipe is the unit and how much straight pipe is needed for installation View answer

Asked 3 ´years ago

Question 24

Will this work with a Hayward system? My current cell communicates with the computer on my system. View answer

Asked 3 ´years ago

Question 25

Should I bring salt generator inside for the winter View answer

Asked 3 ´years ago

Question 26

I have a section of pvc pipe that is 13" in length in the correct location for a salt cell generator. Does this 13" length give me enough space to plumb the unions and the Core-35? Thank you. View answer

Asked 3 ´years ago

Question 27

I just installed the core 35 and it works great. My pump is on a timer and my generator is plugged in. When the pump turns off the unit shows "no flow". Is it ok to just leave it on with the no flow indicator or will cause a problem with my generator ? I have no problem hard wiring it to the timer, do I just cut the plug off and wire to timer ? or is there a separate power cable sold for hard wire to timer ? View answer

Asked 3 ´years ago

Question 28

Can the product be installed vertically as well as horizontally? View answer

Asked 3 ´years ago

Question 29

Can the unit be installed vertically? Video shows horizontal installation. View answer

Asked 3 ´years ago

Question 30

how many amps does the unit pull View answer

Asked 3 ´years ago

Question 31

my current set up is for an intellichlor Model IC40. Will this fit in where the old salt cell used to be? View answer

Asked 4 ´years ago

Question 32

Does this eliminate the need for big bags of salt to put in a salt water pool? Or does it actually use it & recycle it to avoid spending more of the salt bags? View answer

Asked 4 ´years ago

Question 33

How long will the cell last before replacement? Also, how often would I have clean this system? Do you sell a product that will reduce corrosion due to saltwater? View answer

Asked 4 ´years ago

Question 34

Can you use the system with an aluminum above ground pool. View answer

Asked 4 ´years ago

Question 35

I have a CircuPool Core-35 that has calcium build up on the cell. How do i clean this ? View answer

Asked 4 ´years ago

Question 36

what do you do in the winter in California? its says cold water and my pool is growing yellow algae ? is there an override? View answer

Asked 4 ´years ago

Question 37

How often is the cell cleaned and how long does it take to replace it View answer

Asked 4 ´years ago

Question 38

can a timer be put on the Core chlorinators? View answer

Asked 4 ´years ago

Question 39

when and if the cell goes bad do you just replaes the cell or the whole unit? View answer

Asked 4 ´years ago

Question 40

I recently purchased a house with an inground pool that is approximately 10 to 11,000 gallons. I want to convert it from chlorine to a saltwater system and am decided to go with the circu pool core 35 system. My question is does the salt system go in place of where my chlorine feeder is now? Any info would be appreciated as I plan on installing myself and do not want to damage anything. I can also include a picture however it will not let me upload it in this question section. View answer

Asked 4 ´years ago

Question 41

I have an above ground pool with 9000 gallons of water. 12x24x52 above ground. I am looking to purchase the core -35. Is this going to be to much for this size of pool? View answer

Asked 4 ´years ago

Question 42

Does this work inline vertically? View answer

Asked 4 ´years ago

Question 43

Are the core and edge salt systems self cleaning or do they still need to be disassembled and cleaned from time to time? View answer

Asked 4 ´years ago

Question 44

What is the length of the elec.cord for plug in View answer

Asked 4 ´years ago

Question 45

Will this replace the Jandy/Zodiac Aquapure 1400 View answer

Asked 5 ´years ago

Question 46

Power used in 110v mode and 220v mode View answer

Asked 5 ´years ago

Question 47

do you have an adapter to replace a Hayward salt cell and fit in same space? View answer

Asked 5 ´years ago

Question 48

I currently have a Classic RJ unit in need of replacement. Will the Core 35 match up with my current plumbing or will I need some sort of adapters? View answer

Asked 5 ´years ago

Question 49

I am interested in purchasing a CircuPool Core55 SWCG system through Discount Pool. Can you verify that these units carry the EC (Trade Grade) certification. Also, if I replace my current Pentair IC30 SWCG with a CircuPool Core55 unit what plumbing adaptor kit (if any) should i purchase? Thanks View answer

Asked 11 ´months ago

Question 50

Due to limited space, I only have two places where a CORE system would fit and it seems neither option is very good. (1) The unit controls will bump my filter if situated above the pvc. It would fit if placed at a 45 degree angle. Is this an option? (2) The unit can be installed along a vertical section of pvc before my in-floor cleaning system actuator. The unit would be in a section of vertical pvc instead of horizontal. Is this an option? Thank you. View answer

Asked 4 ´years ago

CircuPool CORE-35 Salt Chlorine Generator Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools